Superior steel slabs annual sales growth

After the sheets with a thickness of more than 50 mm pass over the wheeled table, the end of the nest bed is moved downwards by the overhead cranes and placed on the table for the torch cutting machine for cutting in the dimensions requested by the customer. For more information on the Superior steel slabs of premium steel plates, visit our site.

Positive features of Superb steel slabs

Ultrasonic Non-Destructive Testing Device This device is placed after the examination table and before equipping the trimming. Its task is to prevent cracks, voids, etc. in the entire volume of the sheet. Detecting internal defects, including. The sheet is tested to order and to the standards requested by the customer. The results of this test are crucial to optimizing the performance of shear and parting shears.

Billet: Unlike logs, the log is elongated and its cross-section is circular or square with a width of less than 15 cm (or less than 230 cm2). Billets are obtained by direct casting, extrusion, or rolling ingots. Billets are mostly used to produce rebar and wire.

Bloom: If the width of the log is more than 15 cm (or its cross-section is more than 230 cm2) this is called a flower and therefore these two products are usually placed in one category. Bloom rails, beams, boxes, studs, shields etc. Plate: Unlike bloom and log, the cross-section of the slab is not square but rectangular (usually 230 mm thick, 1.25 m wide, and 12 mm long).

Sheets, steel plates, plates, etc. Used to make.

Note: Today, the technologies used in the later stages of producing molten steel, namely in the production of steel products such as casting and rolling, are more or less the same. However, various technologies can be used to obtain molten or crude steel, including blast furnace (BF), arc furnace (EAF) and induction furnace (IMF) methods. Although most of the world’s crude steel production, the blast furnace method is produced, for various reasons, Therefore, it is more justified to use the electric furnace method, especially in Iran.

The main alloying elements added to stainless steel are cream and carbon for ferrite and martensite groups and nickel addition for austenitic and biphasic groups. Some of these alloying elements are intentionally added to stainless steels such as manganese and silicon, or present as impurities in stainless steels. Nitrogen is added to improve the properties of stainless steels such as oxygen, sulfur, and phosphorus, or molybdenum, titanium, copper, and … For more information on steel slabs price visit our site.

Annual sales growth of Superior steel slabs

Annual sales growth of Superior steel slabs is very good and the trade of this product has caused a good exchange rate and attracts many customers. Therefore, for more information about steel slab dimensions, visit our site.