Steel stud to export in bulk

First, it prevents molten material from splashing during immersion of the stud, and secondly, it creates a connecting ring around the stud. When creating an arc, it is recommended to use a dry ceramic flame cover under the moisture of the ceramic, if your ceramic rings are related to rain the night before, it will generate water vapor, which has a great effect on the welding quality, or Local humidity Put it in the oven for a few hours until the moisture is completely removed. For more information on Steel stud to be exported in bulk, visit our site.

How far apart are steel studs?

After dipping Golmikh into the molten pool, the operator should pay attention to the following points:

• 1- Hold the gun or rifle completely upright, the spherical level of the device on the gun is very effective in holding it vertically, not holding the device upright will cause the muzzle of the barrel to not melt properly, which is muzzle strength. connection. Very powerfull.
• 2- Avoid waving your hand while doing Golmikh.
• 3- After immersing the stud in the molten pool for 3 seconds, hold the device steady without shaking until the melted pool cools down.

There is always disagreement between the consultant and the installer of the steel deck over the application of the stud on stairs and inclined surfaces. The constructor declares that the quality of the weld on inclined surfaces is due to unwanted molten material. escape The desired resource should be made. Of course the reasoning argument is correct and logical, but there is a solution to this: Recently, the Golmikh Beta Birth Company began to produce a semi-toothed ceramic flame coating so that the teeth of the half of the ceramic ring and the other half are smooth.

The smooth surface should face downhill to prevent molten material from escaping. Note that we have two types of ceramic flamethrowers: Large toothed ceramic flame cover Fine tooth ceramic flame cover The flame cover or fine toothed ceramic ring is suitable for the realization of the stud where the stud is made directly on the beam and there is no steel floor plate in that part. Also suitable for surfaces with a flame-plated or coarse-toothed ceramic ring, galvanized sheet steel decks. Flame hood or ceramic ring There are some points on the quality of Golmikh’s optimum performance, which we will briefly mention here:

• 1- During welding, the gun should be kept in the first welding position until the molten metal hardens.
• 2- Welding should be avoided if the temperature of the base metal is less than -18 or if the weld surface is wet.
• 3- Use a quality, low carbon and certified stud. Beta and step brands are two well-known and high quality brands. How nails are identified and of good quality
• 4- Power fluctuations affect the welding quality as well as the cable length of the device. See the problems of three-phase electricity and diesel generators.
• 5- The standard method for testing the stud welding is to bend the stud with the lever at an angle of 30 degrees according to the stud welding bending test film.

For more information about structural steel studs, visit our site.

Exporting steel stud in bulk in 2021

Exporting steel stud in bulk in 2021 is done by our company to European and Asian countries and we have been able to increase our sales growth with our good business in this field. Therefore, for more information about load bearing steel studs, you can visit our site.